Working on 12 V vehicle electrical system.
Risk of short circuits! Risk of fire!
Detach the cable from the negative (-) battery terminal.
Before performing work on electronic components, disconnect the cable from the negative (-) battery terminal to prevent damage to the electrical system or components.
When disconnecting the cable, turn the START-STOP button (engine switch) and headlight switch off and loosen the cable nut completely. Perform these operations without twisting or prying on the cable. Then disconnect the cable.
Clock settings, radio settings, audio system memory, DTCs and other data will be cleared when the cable is disconnected from the negative (-) battery terminal. Write down any necessary data before disconnecting the cable.
1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
for B48:
Click hereGeneral>MAINTENANCE>B48 BATTERY>REMOVAL
for B58:
Click hereGeneral>MAINTENANCE>B58 BATTERY>REMOVAL
81330
2.REMOVE NO. 1 LUGGAGE COMPARTMENT LIGHT ASSEMBLY
81604
3.REMOVE TRIANGLE REFLECTOR SET
64716D
4.REMOVE DECK TRIM REAR COVER
62470A
5.REMOVE ROOF SIDE INNER GARNISH ASSEMBLY RH
Use the same procedure as for the LH side.
Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING>REMOVAL
64288D
6.SEPARATE TRANSVERSE PIPE TRIM
Use the same procedure as for the LH side.
62608
7.REMOVE SEAT BELT HOLE COVER SUB-ASSEMBLY RH
Use the same procedure as for the LH side.
Click hereVehicle Interior>SEAT BELT>FRONT SEAT OUTER BELT ASSEMBLY>REMOVAL
66311
8.REMOVE ROPE HOOK (w/ Courtesy Light)
64730C
9.REMOVE DECK TRIM SIDE BOARD AND DECK SIDE TRIM COVER RH
42606B
10.REMOVE TUBELESS TIRE REPAIR KIT (w/ Repair Kit)
Remove the tubeless tire repair kit (1).
44890D
11.REMOVE AIR COMPRESSOR ASSEMBLY (w/ Repair Kit)
Remove the air compressor assembly (1).
12.REMOVE REAR POWER DISTRIBUTION BOX
Remove the transport hook (1) and screwdriver (2).
Detach the claws (2) to remove the rear power distribution box (1).
Open the cover (1).
Loosen the nut (2).
If applicable, loosen the tie band on the positive battery cable (3).
Remove the positive battery cable (3).
Disconnect all the connectors to remove the rear power distribution box (1).