1.INSTALL OIL COOLER TUBE
Materials harmful to health.
Contact with fluids harmful to health!
Note and follow safety information on containers.
Conduct all work in appropriate personal protective equipment only.
Fasten the oil cooler tubes in the No. 1 automatic transmission oil cooler tube clamp.
Tighten down the T25 screw.
Replace O-rings (1).
Connect the No. 1 oil cooler inlet tube and No. 1 oil cooler outlet tube to the transmission oil thermostat.
Tighten down the bolt.
Position the oil cooler tubes in the No. 3 automatic transmission oil cooler tube clamp.
Secure the No. 3 automatic transmission oil cooler tube clamp.
Tighten down the T25 screw.
16454C
2.INSTALL RADIATOR SIDE PLATE LH
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
Install the radiator side plate LH.
Connect and lock the oil cooler tubes.
Clip in the oil cooler tubes in marked areas.
Tighten the T30 bolts.
16546B
3.INSTALL LOWER RADIATOR PROTECTOR
Attach the guides to install the lower radiator protector.
16546A
4.INSTALL UPPER RADIATOR PROTECTOR
Attach the guides to install the upper radiator protector.
33493A
5.INSTALL TRANSMISSION OIL COOLER
16041
6.INSTALL NO. 2 RADIATOR ASSEMBLY (for B48)
16041
7.INSTALL NO. 2 RADIATOR ASSEMBLY (for B58)
16400
8.INSTALL RADIATOR ASSEMBLY (for B48)
16400
9.INSTALL RADIATOR ASSEMBLY (for B58)
10.ADJUST AUTOMATIC TRANSMISSION FLUID LEVEL
11.INSPECT FOR AUTOMATIC TRANSMISSION FLUID LEAK