Home › Drivetrain › 8HP51 (AUTOMATIC TRANSMISSION / TRANSAXLE) › OIL COOLER
RM3650E _52 Drivetrain _079902 8HP51 AUTOMATIC TRANSMISSION / TRANSAXLE _0387751 OIL COOLER A

8HP51 AUTOMATIC TRANSMISSION / TRANSAXLE  OIL COOLER  INSTALLATION  


PROCEDURE

Hide 33493A 1.INSTALL TRANSMISSION OIL COOLER

CAUTION:
·

Hot surfaces.

Risk of burning!

-

Perform all work only on components that have cooled down.




HINT:

Collect and dispose of emerging fluids. Observe country-specific waste disposal regulations.


a.
C413376

Thread in transmission oil cooler (1) in direction of arrow through the opening in the front air duct (2) and install.


b.
C413375

Position transmission oil cooler (3) an insert into holders (2) in direction of arrow.


c.

Connect oil cooler tubes (1) and lock.

HINT:

The oil cooler tubes (1) must engage audibly.



Hide 53896B 3.INSTALL FRONT FENDER SPLASH FRONT SHIELD LH

Hide 53895B 4.INSTALL FRONT FENDER SPLASH FRONT SHIELD RH

HINT:

Use the same procedure as for the LH side.


Hide 51410 5.INSTALL NO. 1 ENGINE UNDER COVER ASSEMBLY

Hide 6.ADJUST AUTOMATIC TRANSMISSION FLUID LEVEL

Hide 7.INSPECT FOR AUTOMATIC TRANSMISSION FLUID LEAK