Home › Drivetrain › 8HP51 (AUTOMATIC TRANSMISSION / TRANSAXLE) › TRANSMISSION OIL THERMOSTAT
RM3650E _52 Drivetrain _079902 8HP51 AUTOMATIC TRANSMISSION / TRANSAXLE _0387746 TRANSMISSION OIL THERMOSTAT A

8HP51 AUTOMATIC TRANSMISSION / TRANSAXLE  TRANSMISSION OIL THERMOSTAT  INSTALLATION  


PROCEDURE

Hide 32971 1.INSTALL TRANSMISSION OIL THERMOSTAT

a.
C413377

Replace O-rings (1).


b.
C413387

Replace O-rings (1).


c.

Install the transmission oil thermostat in the connections on the automatic transmission assembly.


d.

Tighten down the bolt.

Torque:
8.0 N*m (82 kgf*cm, 71 in.*lbf)


e.

Install the oil cooler tubes in the transmission oil thermostat.


f.

Tighten down the bolt.

Torque:
8.0 N*m (82 kgf*cm, 71 in.*lbf)


g.

Insert and install the No. 1 floor heat insulator.


h.

Tighten nuts.

Torque:
2.6 N*m (27 kgf*cm, 23 in.*lbf)


Hide 2.ADJUST AUTOMATIC TRANSMISSION FLUID LEVEL

Hide 3.INSPECT FOR AUTOMATIC TRANSMISSION FLUID LEAK