Home › Drivetrain › 8HP51 (AUTOMATIC TRANSMISSION / TRANSAXLE) › TORQUE CONVERTER RADIAL SHAFT SEAL
RM3650E _52 Drivetrain _079902 8HP51 AUTOMATIC TRANSMISSION / TRANSAXLE _0387754 TORQUE CONVERTER RADIAL SHAFT SEAL A

8HP51 AUTOMATIC TRANSMISSION / TRANSAXLE  TORQUE CONVERTER RADIAL SHAFT SEAL  INSTALLATION  


PROCEDURE

Hide 1.INSTALL TORQUE CONVERTER RADIAL SHAFT SEAL

a.
C413414

Replace the T50 bolts (1).

HINT:
·

To do so, it is essential to use the new parts from the drive repair kit.

·

The 13 T50 bolts (1) in the drive repair kit are equipped with a sealing ring.




b.

Replace and hand-tighten the T50 bolts (1) along the dotted line.

HINT:

The T50 bolts (1) must be replaced one by one. Only ever replace a T50 bolt (1) one at a time.



c.
C413415

Tighten the T50 bolts in the order (1) to (13).

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)


d.

Using SST, tighten the T50 bolts an additional 90°

SST
09900-WA010  

HINT:
·
C417459C02
2.99,1.271 3.156,1.188 false 2.906,2.094 2.906,1.76 false 0.875,3 1.208,3 false 0.104,0.125 0.417,0.281 0.313,0.156 10 false *a 0.448,0.125 0.76,0.281 0.313,0.156 10 false *b 2.042,0.125 2.354,0.281 0.313,0.156 10 false *c 3.188,1.073 3.427,1.271 0.24,0.198 10 false *d 2.854,2.146 3.167,2.302 0.313,0.156 10 false *b 1.302,2.927 1.615,3.083 0.313,0.156 10 false *c
*a Example
*b Before Tightening
*c After Tightening
*d Magnetic Portion



·

The magnetic portion is used to secure the gauge to the vehicle.

·

After first adjusting the needle of the gauge to 0°, tighten to the specified angle.

·

Perform the work procedure carefully so that the gauge, etc. does not become tilted.




e.
C413420

Install the O-ring on the drive shaft.


f.
C413416

Oil the sealing lip of the torque converter radial shaft seal with ATF.


g.

Strike the torque converter radial shaft seal (1) with the special tool 0 496 719 (24 1 410) until it reaches the limit position.

SST
09300-WA060