Home › Vehicle Interior › METER / GAUGE / DISPLAY › COMBINATION METER
RM3650E _58 Vehicle Interior _079903 METER / GAUGE / DISPLAY _0387766 COMBINATION METER A

METER / GAUGE / DISPLAY  COMBINATION METER  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for LHD and RHD vehicles.

·

The following procedure is for LHD vehicles.



PROCEDURE

Hide 1.INSTALL COMBINATION METER ASSEMBLY

a.
E415587

When installing the combination meter assembly (2), make sure that the retaining tabs (1) are positioned correctly.


b.
E415586

Attach wiring harness in the holder (2) on the combination meter assembly (3).


c.

Connect connectors (1) and lock.


d.
E415588C01
0,0 0,0 false
V113147

Install in this Direction


Position combination meter assembly (2) and attach the retaining tabs (1) to install it in direction of arrow.


e.
E415585

Tighten the T20 screws (1).

Torque:
1.5 N*m (15 kgf*cm, 13 in.*lbf)


Hide 2.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Hide 3. ENCODE/PROGRAM CONTROL UNIT(S)

NOTICE:
·

Use the most recent software version to prevent faults during programming/encoding.

·

The battery voltage must not drop below 13.0 V during programming.

·

Use only recommended chargers for a low-voltage vehicle electrical system.

·

Do not exceed the maximum charging voltage of 14.8 V when charging the battery.

·

When there is communication abnormality in the middle of work, control unit might be damaged.

·

It may be necessary to perform the Action Plan several times.



a.

Connect the battery charger to the vehicle.


b.

Connect the diagnosis system with the vehicle.


c.

Determine the action plan.

Service plan / Programming plan / Action plan / Calculate action plan


d.

Accept and fully process the measures plan.

Service plan / Programming plan / Action plan / Perform action plan


e.

Wait until programming/encoding has been completed.

NOTICE:

When there is communication abnormality in the middle of work, control unit might be damaged.



f.

Carry out vehicle test.

Vehicle management / Troubleshooting / Fault memory / Calculate test plan


g.

Delete the fault memory.

Vehicle management / Troubleshooting / Fault memory / Delete fault memory


h.

Disconnect the diagnosis system from the vehicle.


i.

Disconnect the battery charger from the vehicle.