Home › General › MAINTENANCE › B58 BATTERY
RM3650E _V1 General _079881 MAINTENANCE _0391789 B58 BATTERY A

MAINTENANCE  B58 BATTERY  INSTALLATION  


PROCEDURE

Hide 28800 1.INSTALL BATTERY

a.
A442552

Install battery (1) in the direction of the arrow.


b.

Position the battery holder (2) and tighten the bolt (3).

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)


c.

Replace bolts (5).


d.

Position the bracket (4) of the removable panel and tighten the bolts (5).

Torque:
8.0 N*m (82 kgf*cm, 71 in.*lbf)


e.
A442550

Clip No. 1 indoor electrical key antenna assembly (1) into the latch mechanisms (2) of the holder.


f.

Mount battery hose and make sure it is fitted correctly.

CAUTION:
·

Gas emission.

Danger of injury! Danger of explosion!

-

Assign the vent holes correctly.

-

Route the battery hose correctly.




HINT:
A447469

The battery has two vent holes, opposite:

One vent hole (1) must be closed correctly with a dummy plug.

The battery hose (3) must be correctly connected and routed at the other vent hole (2).


i.

Check if the vent hole (1) is correctly closed with a dummy plug.

HINT:

No dummy plug.

Close the vent hole (1) correctly with a dummy plug.



ii.

Check if the vent hole (2) has a correctly connected battery hose (3).

HINT:

The battery hose (3) is not correctly connected.

At the vent hole (2), connect the battery hose (3) correctly.



iii.

Check if battery hose (3) is routed to the outside with a downhill gradient (no siphon formation!).

HINT:

The battery hose (3) is not correctly routed as shown in the image on the right.

Route the battery hose (3) correctly as shown in the center image.




g.
A442548

Connect the safety battery terminal (3) to the positive (+) battery terminal.


h.

Tighten nut (2).

Torque:
5.0 N*m (51 kgf*cm, 44 in.*lbf)


i.

Close the cover (1) of the safety battery terminal.


j.
A442547

Insert the connector cover (1) at the guides (3) and engage in the latch mechanism (2).


Hide 2.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

a.
A442543

Connect the No. 3 earth wire (2) from the negative (-) battery terminal.


b.

Tighten nut (1).

Torque:
5.0 N*m (51 kgf*cm, 44 in.*lbf)


Hide 64711B 3.INSTALL DECK BOARD ASSEMBLY

Hide 64330D 4.INSTALL PACKAGE TRAY TRIM PANEL ASSEMBLY

Hide 28800 5. REGISTER BATTERY EXCHANGE

a.

Connect the diagnosis system to the vehicle and enter the following menus:

Vehicle management / Service functions / Body / Voltage supply / ABL Register battery change