Wear protective gloves. Sharp areas on the parts may injure your hands.
Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
1.INSTALL BELT WARNING OCCUPANT DETECTION SENSOR
Install the belt warning occupant detection sensor (1) to the front seat assembly carefully.
Attach the cable (4) to the holder (5).
Attach the claws (2) and clamp (3).
|
Install in this Direction |
Attach the claws (6) correctly to install the connectors to the connector housing (5) in order of (4) to (1) in the direction of the arrow.
Fasten the tie band.
2.INSTALL FRONT SEAT ASSEMBLY (for Manual Seat)
Use the same procedure as for the driver side.
Click hereVehicle Interior>SEAT>FRONT SEAT ASSEMBLY (for Manual Seat)>INSTALLATION
3.INSTALL FRONT SEAT ASSEMBLY (for Power Seat)
Use the same procedure as for the driver side.
Click hereVehicle Interior>SEAT>FRONT SEAT ASSEMBLY (for Power Seat)>INSTALLATION