Wear protective gloves. Sharp areas on the parts may injure your hands.
Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
Use the same procedure for the driver side and front passenger side.
The procedure listed below is for the driver side.
1.INSTALL FRONT SEAT ASSEMBLY
Cover the front door scuff plate with protective covers.
Place the front seat assembly in the vehicle with another person.
Heavy component.
Heavy components can lead to injury or damage.
Remove and install heavy components with the aid of another person/other persons.
Protect the front seat leg.
Be careful not to damage the front seat assembly, body exterior or body interior.
Tilt the front seat assembly backwards to connect the connector.
Move the front seat assembly to the foremost position.
Set the seat cushion height of the front seat assembly to the uppermost position.
Tighten the T50 bolts (1).
Move the front seat assembly to the rearmost position.
Tighten the T50 bolts (1).
Connect the cable to the negative (-) battery terminal.
for B48:
for B58:
73220
2.CONNECT FRONT SEAT OUTER BELT ASSEMBLY
3. ENCODE/PROGRAM CONTROL UNIT(S) (w/ Occupant Detection ECU)
Use the most recent software version to prevent faults during programming/encoding.
The battery voltage must not drop below 13.0 V during programming.
Use only recommended chargers for a low-voltage vehicle electrical system.
Do not exceed the maximum charging voltage of 14.8 V when charging the battery.
When there is communication abnormality in the middle of work, control unit might be damaged.
It may be necessary to perform the Action Plan several times.
Connect the battery charger to the vehicle.
Connect the diagnosis system with the vehicle.
Determine the action plan.
Service plan / Programming plan / Action plan / Calculate action plan
Accept and fully process the measures plan.
Service plan / Programming plan / Action plan / Perform action plan
Wait until programming/encoding has been completed.
When there is communication abnormality in the middle of work, control unit might be damaged.
Carry out vehicle test.
Vehicle management / Troubleshooting / Fault memory / Calculate test plan
Delete the fault memory.
Vehicle management / Troubleshooting / Fault memory / Delete fault memory
Disconnect the diagnosis system from the vehicle.
Disconnect the battery charger from the vehicle.