Wear protective gloves. Sharp areas on the parts may injure your hands.
Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
Use the same procedure for the driver side and front passenger side.
The procedure listed below is for the driver side.
73240
1.INSTALL FRONT SEAT INNER BELT ASSEMBLY
|
Install in this Direction |
Attach the claws (4) to install the connector (1) to the connector housing (2) in the direction of the arrow.
Fasten the cables to the connector housing (2) with the tie band (3).
Attach the cable (1) in the holder (2).
Replace the T50 bolt (1).
Tighten the T50 bolt (1).
Attach the clamps (2).
2.INSTALL FRONT SEAT ASSEMBLY (for Manual Seat)
3.INSTALL FRONT SEAT ASSEMBLY (for Power Seat)