Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › STEERING PAD
RM3650E _58 Vehicle Interior _079907 SUPPLEMENTAL RESTRAINT SYSTEMS _0387801 STEERING PAD A

SUPPLEMENTAL RESTRAINT SYSTEMS  STEERING PAD  INSTALLATION  


PROCEDURE

Hide 45130 1.INSTALL HORN BUTTON ASSEMBLY

a.

Check that the START-STOP button (engine switch) off.

HINT:
A439562

Pressing and holding the AUDIO button changes the power source mode to IG OFF.



b.

Check that the cable is disconnected from the negative (-) battery terminal.

CAUTION:
·

Wait at least 60 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

·

If the airbag deploys for any reason, it may cause a serious accident.




c.
B538746

Connect the connectors (1) and lock.

HINT:
B538766

Install the connector (1) to the steering wheel assembly connector holder (2).



d.
B538707

Apply even amounts of pressure and press the horn button assembly (1) into the steering wheel assembly until the airbag unit audibly and noticeably engages.

NOTICE:

After installation, try to pull the horn button assembly and check that the horn button assembly is securely installed.



Hide 2.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Hide 45130 3.INSPECT HORN BUTTON ASSEMBLY

a.

Make sure that the horn sounds.