Use the same procedure for both the LH and RH sides.
The procedure described below is for the LH side.
62170A
1.INSTALL CURTAIN SHIELD AIRBAG ASSEMBLY
Check that the START-STOP button (engine switch) off.
Pressing and holding the AUDIO button changes the power source mode to IG OFF.
Check that the cable is disconnected from the negative (-) battery terminal.
Wait at least 60 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
If the airbag deploys for any reason, it may cause a serious accident.
Attach the guides (4) to install the curtain shield airbag assembly (3).
Tighten the T30 bolts (2).
Connect the plug connection (1) and lock.
Attach the clamps (2).
Attach the guide (3).
Tighten the T30 bolt (1).
63310
2.INSTALL ROOF HEADLINING ASSEMBLY