Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › FRONT AIRBAG SENSOR
RM3650E _58 Vehicle Interior _079907 SUPPLEMENTAL RESTRAINT SYSTEMS _0387810 FRONT AIRBAG SENSOR A

SUPPLEMENTAL RESTRAINT SYSTEMS  FRONT AIRBAG SENSOR  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 89173 1.INSTALL FRONT AIRBAG SENSOR

a.

Check that the START-STOP button (engine switch) off.

HINT:
A439562

Pressing and holding the AUDIO button changes the power source mode to IG OFF.



b.

Check that the cable is disconnected from the negative (-) battery terminal.

CAUTION:
·

Wait at least 60 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

·

If the airbag deploys for any reason, it may cause a serious accident.




c.
B538719

Attach the guide (4) to install the front airbag sensor (3).


d.

Replace the T30 bolt (2).


e.

Tighten the T30 bolt (2).

Torque:
8.0 N*m (82 kgf*cm, 71 in.*lbf)


f.

Connect the connectors (1) and lock.


Hide 81150 2.INSTALL HEADLIGHT ASSEMBLY