Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › POP UP HOOD SENSOR
RM3650E _58 Vehicle Interior _079907 SUPPLEMENTAL RESTRAINT SYSTEMS _0387814 POP UP HOOD SENSOR A

SUPPLEMENTAL RESTRAINT SYSTEMS  POP UP HOOD SENSOR  INSTALLATION  


PROCEDURE

Hide 1.INSTALL PEDESTRIAN DETECTION CHAMBER ASSEMBLY

a.

Check that the START-STOP button (engine switch) off.

HINT:
A439562

Pressing and holding the AUDIO button changes the power source mode to IG OFF.



b.

Check that the cable is disconnected from the negative (-) battery terminal.

CAUTION:
·

Wait at least 60 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

·

If the airbag deploys for any reason, it may cause a serious accident.




c.
B538716

Replace the front bumper energy absorber (2).

HINT:

The front bumper energy absorber must be replaced.



d.

Carefully install the pedestrian detection chamber assembly (1) to the front bumper energy absorber (2).


e.
B538715

Attach the claws (3) to install the front bumper energy absorber with pedestrian detection chamber assembly (2).


f.

Connect connectors (1) and lock.


Hide 52119A 2.INSTALL FRONT BUMPER COVER