Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › FRONT BUMPER
RM3650E _59 Vehicle Exterior _079982 EXTERIOR PANELS / TRIM _0387964 FRONT BUMPER A

EXTERIOR PANELS / TRIM  FRONT BUMPER  INSTALLATION  


PROCEDURE

Hide 1.INSTALL FRONT BUMPER ASSEMBLY

a.
B612731

Engage the fasteners to temporarily install the front bumper assembly (1).


b.
B537230

Engage the guides (2) and clamps (1) to install the front bumper assembly.


c.
B537229

Install the bolts (1).

Torque:
8.0 N*m (82 kgf*cm, 71 in.*lbf)


d.
B537228

Install the screws (arrowed).

Torque:
3.0 N*m (31 kgf*cm, 27 in.*lbf)


e.
B537227

Engage the clamp (2).

HINT:

Perform the operations on the left and right side.



f.

Connect the connector (1).

HINT:

Perform the operations on the left and right side.



g.
B537226

Engage the clamp (2).

HINT:

Perform the operations on the left and right side.



h.

Install the T20 screws (1).

HINT:

Perform the operations on the left and right side.



i.

Remove the protective tape.


Hide 53826A 2.INSTALL FRONT FENDER UPPER PROTECTOR LH

a.
B537223

Install the front fender upper protector LH (3).


b.

Install the clips (1) and clips (2).


Hide 53825A 3.INSTALL FRONT FENDER UPPER PROTECTOR RH

HINT:

Use the same procedure as for the LH side.


Hide 53381 4.INSTALL HOOD TO RADIATOR SUPPORT SEAL

a.

Install the hood to radiator support seal.


Hide 53879 5.INSTALL FRONT FENDER LINER LH

a.
B537221

Install the front fender liner LH (1) with 13 screws and clip.

Torque:
2.6 N*m (27 kgf*cm, 23 in.*lbf)


Hide 53878 6.INSTALL FRONT FENDER LINER RH

HINT:

Use the same procedure as for the LH side.


Hide 7.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Hide 9.ADJUST MILLIMETER WAVE RADAR SENSOR (w/ Toyota Supra Safety)