Home › Suspension › SUSPENSION CONTROL › FRONT ACCELERATION SENSOR
RM3650E _53 Suspension _079980 SUSPENSION CONTROL _0387938 FRONT ACCELERATION SENSOR A

SUSPENSION CONTROL  FRONT ACCELERATION SENSOR  REMOVAL  


CAUTION / NOTICE / HINT

CAUTION:
·

Vehicle may slip off the vehicle hoist if the vehicle hoist is handled incorrectly.

Danger! Life-threatening injuries!

-

Observe safety information on raising the vehicle using a vehicle hoist.




CAUTION / NOTICE / HINT

NOTICE:
·

Electrostatic discharge.

Damage to or destruction of electrical components.

-

Only touch the housings of electrical components. Do not touch pins or multi-pin connectors directly.

-

For additional information see:

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION




HINT:
·

Use the same procedure for the RH side and LH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 1.REMOVE ACCELERATION SENSOR ASSEMBLY

a.
C413674

Unlock plug connection (1) and disconnect.


b.

Loosen E10 bolt (2).


c.

Remove the acceleration sensor assembly (3).