Home › Suspension › FRONT SUSPENSION › FRONT LOWER SUSPENSION ARM
RM3650E _53 Suspension _079510 FRONT SUSPENSION _0387944 FRONT LOWER SUSPENSION ARM A

FRONT SUSPENSION  FRONT LOWER SUSPENSION ARM  REMOVAL  


CAUTION / NOTICE / HINT

CAUTION:
·

Vehicle may slip off the vehicle hoist if the vehicle hoist is handled incorrectly.

Danger! Life-threatening injuries!

-

Observe safety information on raising the vehicle using a vehicle hoist.




HINT:
·

Use the same procedure for the RH side and LH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 1.REMOVE FRONT WHEEL

Hide 53876F 2.REMOVE FRONT NO. 2 FENDER LINER

a.
C413452

Loosen screws (1).


b.

Loosen nuts (2).


c.

Release the plastic rivet (3) and remove the front No. 2 fender liner (4).


Hide 3.REMOVE FRONT LOWER SUSPENSION ARM ASSEMBLY

NOTICE:
·

Component damage caused by striking tools.

Brute force can result in component damage.

-

Only use those tools intended for the work.




a.
C413445

for LH Side:

i.

Release the front height control sensor link sub-assembly (1) on the front lower suspension arm assembly.



b.
C413453

Loosen the nut (1), if necessary, counter-hold the T40 "TORX" socket wrench.


c.
C413446

Using a 18 mm deep socket wrench, unscrew the nut (1) and remove the 18 mm bolt to the rear.


d.

Remove the front lower suspension arm assembly.