Home › Suspension › REAR SUSPENSION › REAR UPPER ARM
RM3650E _53 Suspension _079981 REAR SUSPENSION _0387953 REAR UPPER ARM A

REAR SUSPENSION  REAR UPPER ARM  REMOVAL  


CAUTION / NOTICE / HINT

CAUTION:
·

Motor vehicle may slip off the vehicle hoist where components are supported.

Danger! Life-threatening injuries!

-

Secure the vehicle hoist against lowering and lifting.


·

Motor vehicle may slip off the vehicle hoist if the weight is distributed unevenly.

Danger! Life-threatening injuries!

-

Ensure there is a specific weight compensation on the motor vehicle.


·

Vehicle may slip off the vehicle hoist if the vehicle hoist is handled incorrectly.

Danger! Life-threatening injuries!

-

Observe safety information on raising the vehicle using a vehicle hoist.




HINT:
·

Use the same procedure for the RH side and LH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 51206A 1.REMOVE REAR SUSPENSION MEMBER SUB-ASSEMBLY

Hide 48790 2.REMOVE REAR UPPER CONTROL ARM ASSEMBLY

CAUTION:
·

The rear suspension member sub-assembly is a very heavy component. Make sure that it is supported securely.

·

If the rear suspension member sub-assembly is not securely supported, it may drop, resulting in serious injury.



NOTICE:

Use attachments and wooden blocks to keep the rear suspension member sub-assembly level.


a.
C413567

Unfasten 18 mm nut (1).


b.

Remove the 16 mm bolt (2).


c.
C413568

Release bolt (1) and remove the rear upper control arm assembly (2).


Hide 48790F 3.REMOVE REAR NO. 2 UPPER CONTROL ARM ASSEMBLY

CAUTION:
·

The rear suspension member sub-assembly is a very heavy component. Make sure that it is supported securely.

·

If the rear suspension member sub-assembly is not securely supported, it may drop, resulting in serious injury.



NOTICE:

Use attachments and wooden blocks to keep the rear suspension member sub-assembly level.


a.
C413564

Loosen E12 bolts (1).


b.

Remove rear No. 1 stabilizer bar bracket (2) from the rear stabilizer bar.


c.
C413565

Unfasten 18 mm nut (1).


d.

Remove the 16 mm bolt (2).


e.
C413566

Loosen 18 mm nut (2).


f.

Remove the 18 mm bolt (1).


g.

Remove rear No. 2 upper control arm assembly (3).