1.REMOVE REAR BUMPER ASSEMBLY
89342B
2.REMOVE REAR SIDE ULTRASONIC SENSOR
The illustration is for the LH side.
orientation for the RH side is the opposite of the LH side.
Unlock plug connection (1) and disconnect.
Detach the claws (1) to remove the rear side ultrasonic sensor (2).
Remove the ultrasonic sensor O-ring (1).
89342
3.REMOVE REAR CORNER ULTRASONIC SENSOR
Use the same procedure as for the rear side ultrasonic sensor.
89342A
4.REMOVE REAR CENTER ULTRASONIC SENSOR
The illustration is for the LH side.
orientation for the RH side is the opposite of the LH side.
Unlock plug connection (1) and disconnect.
Detach the claws (1) to remove the rear center ultrasonic sensor (2).
Remove the ultrasonic sensor O-ring (1).
89348A
5.REMOVE NO. 2 ULTRASONIC SENSOR RETAINER
Perform this procedure only when replacement of the No. 2 ultrasonic sensor retainer is necessary.
When removing the No. 2 ultrasonic sensor retainer, heat the rear bumper assembly and No. 2 ultrasonic sensor retainer using a heat light.
The illustration is for the LH side.
orientation for the RH side is the opposite of the LH side.
Heat the rear bumper assembly and No. 2 ultrasonic sensor retainer using a heat light at the specified temperature.
| Item | Temperature |
|---|---|
| Rear Bumper Assembly | 40 to 50°C (104 to 122°F) |
| No. 2 Ultrasonic Sensor Retainer |
| *a | Heated Part |
| *b | Heat Light |
Do not touch the heat light and heated parts.
Touching the heat light may result in burns.
Touching heated parts for a long time may result in burns.
for rear side:
Disengage the clamp (1).
Remove the No. 2 ultrasonic sensor retainer (2).
for rear corner side:
Disengage the clamp (1).
Remove the No. 2 ultrasonic sensor retainer (2).
for rear center side:
Disengage the clamp (1).
Remove the No. 2 ultrasonic sensor retainer (1).