Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › BLIND SPOT MONITOR SENSOR
RM3650E _56 Audio / Visual / Telematics _080021 PARK ASSIST / MONITORING _0388109 BLIND SPOT MONITOR SENSOR A

PARK ASSIST / MONITORING  BLIND SPOT MONITOR SENSOR  INSTALLATION  


PROCEDURE

Hide 1.INSTALL BLIND SPOT MONITOR SENSOR LH

a.
E415881C01
0,0 0,0 false
V100136

Install in this Direction


Attach the claws (1) to install the blind spot monitor sensor (2) in the direction of the arrow.


b.
E415879

Attach the clips (2) to connect the wiring harness (3).


c.

Connect connector (1) and lock.


Hide 2.INSTALL BLIND SPOT MONITOR SENSOR RH

HINT:

Use the same procedure as for the LH side.


Hide 52616B 3.INSTALL ABSORBER FUNNEL LH

a.
E415882

Attach the claws (2) to install the absorber funnel LH (1).


Hide 52615C 4.INSTALL ABSORBER FUNNEL RH

HINT:

Use the same procedure as for the LH side.


Hide 5.INSTALL REAR BUMPER ASSEMBLY

Hide 6. ENCODE/PROGRAM CONTROL UNIT(S)

NOTICE:
·

Use the most recent software version to prevent faults during programming/encoding.

·

The battery voltage must not drop below 13.0 V during programming.

·

Use only recommended chargers for a low-voltage vehicle electrical system.

·

Do not exceed the maximum charging voltage of 14.8 V when charging the battery.

·

When there is communication abnormality in the middle of work, control unit might be damaged.

·

It may be necessary to perform the Action Plan several times.



a.

Connect the battery charger to the vehicle.


b.

Connect the diagnosis system with the vehicle.


c.

Determine the action plan.

Service plan / Programming plan / Action plan / Calculate action plan


d.

Accept and fully process the measures plan.

Service plan / Programming plan / Action plan / Perform action plan


e.

Wait until programming/encoding has been completed.

NOTICE:

When there is communication abnormality in the middle of work, control unit might be damaged.



f.

Carry out vehicle test.

Vehicle management / Troubleshooting / Fault memory / Calculate test plan


g.

Delete the fault memory.

Vehicle management / Troubleshooting / Fault memory / Delete fault memory


h.

Disconnect the diagnosis system from the vehicle.


i.

Disconnect the battery charger from the vehicle.