Hot surfaces.
Risk of burning!
Perform all work only on components that have cooled down.
Heavy component.
Heavy components can lead to injury or damage.
Remove and install heavy components with the aid of another person/other persons.
Component with heavy weight.
Danger of injury!
Note component's center of gravity.
Support component using a jack.
Secure component against falling off the jack.
Swarf resulting from sawing or grinding components.
Danger of injury!
Conduct all work in appropriate personal protective equipment only.
Wear safety goggles and protective gloves.
57628E
1.REMOVE REAR FLOOR SIDE MEMBER COVER LH
57627G
2.REMOVE REAR FLOOR SIDE MEMBER COVER RH
Use the same procedure as for the LH side.
58252
3.REMOVE REAR FLOOR PANEL BRACE
58724G
4.REMOVE REAR UNDERBODY PROTECTOR LH
58723F
5.REMOVE REAR UNDERBODY PROTECTOR RH
Use the same procedure as for the LH side.
17430
6.REMOVE EXHAUST TAIL PIPE ASSEMBLY
Hot surfaces.
Risk of burning!
Perform all work only on components that have cooled down.
If the separation point is not marked by a punch mark in the pipe, determine the separation point by means of the pipe length on the new component.
Transfer the separation point to the faulty component and mark.
Cut through the faulty component at the marked point with a suitable tool.
Deburr the separation point and remove any swarf. There is a risk of remaining metal chips at the joint between the two pipes.
Check the exhaust pipe assembly for tightness after installation.
If the separation point (1) is not marked by a punch mark in the pipe, determine the separation point (1) by means of the pipe length on the new component.
Transfer the separation point (1) to the component to be replaced and mark.
Cut through separation point at the marked point with the special tool 0 496 469 (00 2 220).
Unlock plug connection (1) and disconnect.
Loosen nuts (1).
Loosen nuts (1).
Unfasten nut (1).
Remove the exhaust tail pipe assembly.