Home › Engine / Hybrid System › B58 (INTAKE / EXHAUST) › TAIL EXHAUST PIPE ASSEMBLY
RM3650E _51 Engine / Hybrid System _080024 B58 INTAKE / EXHAUST _0388154 TAIL EXHAUST PIPE ASSEMBLY A

B58 INTAKE / EXHAUST  TAIL EXHAUST PIPE ASSEMBLY  INSTALLATION  


PROCEDURE

Hide 17430 1.INSTALL EXHAUST TAIL PIPE ASSEMBLY

CAUTION:
·

Hot surfaces.

Risk of burning!

-

Perform all work only on components that have cooled down.




HINT:
·

If the separation point is not marked by a punch mark in the pipe, determine the separation point by means of the pipe length on the new component.

·

Transfer the separation point to the faulty component and mark.

·

Cut through the faulty component at the marked point with a suitable tool.

·

Deburr the separation point and remove any swarf. There is a risk of remaining metal chips at the joint between the two pipes.

·

Check the exhaust system for tightness after installation.



a.

Position the exhaust tail pipe assembly.


b.

Replace nut.


c.

Tighten nut.

Torque:
19 N*m (194 kgf*cm, 14 ft.*lbf)


d.
A442385

Replace nuts.


e.

Tighten nuts.

Torque:
19 N*m (194 kgf*cm, 14 ft.*lbf)


f.
A442386

Replace nuts.


g.

Tighten nuts.

Torque:
19 N*m (194 kgf*cm, 14 ft.*lbf)


h.
A442391

Tighten nuts in the area (1) at the rear No. 1 exhaust tail pipe clamps (2).

Torque:
45 N*m (459 kgf*cm, 33 ft.*lbf)


i.

Connect connectors and lock.


Hide 58724G 2.INSTALL REAR UNDERBODY PROTECTOR LH

Hide 58723F 3.INSTALL REAR UNDERBODY PROTECTOR RH

HINT:

Use the same procedure as for the LH side.


Hide 58252 4.INSTALL REAR FLOOR PANEL BRACE

Hide 57628E 5.INSTALL REAR FLOOR SIDE MEMBER COVER LH

Hide 57627G 6.INSTALL REAR FLOOR SIDE MEMBER COVER RH

HINT:

Use the same procedure as for the LH side.