Home › Engine / Hybrid System › B48 (ENGINE CONTROL) › CAMSHAFT OIL CONTROL SOLENOID
RM3650E _51 Engine / Hybrid System _080056 B48 ENGINE CONTROL _0388303 CAMSHAFT OIL CONTROL SOLENOID A

B48 ENGINE CONTROL  CAMSHAFT OIL CONTROL SOLENOID  INSTALLATION  


PROCEDURE

Hide 15370J 1.INSTALL CAM TIMING OIL CONTROL SOLENOID ASSEMBLY

a.
A445900

Position the vanos actuator at the cylinder head cover sub-assembly.

NOTICE:

The figure shows the rear side of the engine.



b.

Position SST correctly on the vanos actuator.

SST
09960-10010  (09962-01000, 09963-00350)


c.
A445903

for Exhaust Side:

i.

Turn the vanos actuator on the exhaust adjuster (1) with SST in the direction of the arrow until the limit positions rest against the clamps.

SST
09960-10010  (09962-01000, 09963-00350)



d.
A445904

for Intake Side:

i.

Turn the vanos actuator on the intake adjuster (1) with SST in the direction of the arrow until the limit positions rest against the clamps.

SST
09960-10010  (09962-01000, 09963-00350)



e.
A441807

Connect both connectors (1) to the vanos actuator and route the cable correctly.


Hide 11271A 2.INSTALL REAR CYLINDER BLOCK COVER

Hide 55789B 3.INSTALL NO. 2 COWL TOP VENTILATOR LOUVER PROTECTOR

Hide 12601B 4.INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY

Hide 55788A 5.INSTALL COWL TOP VENTILATOR LOUVER PROTECTOR

Hide 53681 6.INSTALL UPPER FRONT SUSPENSION CENTER BRACE