Home › Engine / Hybrid System › B48 (ENGINE CONTROL) › KNOCK SENSOR (for Bank 2)
RM3650E _51 Engine / Hybrid System _080056 B48 ENGINE CONTROL _0388315 KNOCK SENSOR(for Bank 2) A

B48 ENGINE CONTROL  KNOCK SENSOR(for Bank 2)  INSTALLATION  


PROCEDURE

Hide 89615 1.INSTALL KNOCK SENSOR

HINT:

When installing the knock sensor, the tightening torque must be observed.

Non-compliance with the tightening torque can lead to malfunction.


a.

Clean the contact surface of the knock sensor at the cylinder block sub-assembly.


b.

Install knock sensor.


c.

Tighten down E10 bolt.

Torque:
21.5 N*m (219 kgf*cm, 16 ft.*lbf)

NOTICE:

Observe tightening torque without fail.



d.

Connect and lock the connector.

HINT:

The connector must engage audibly.