Home › Engine / Hybrid System › B48 (INTAKE / EXHAUST) › INTAKE MANIFOLD
RM3650E _51 Engine / Hybrid System _080067 B48 INTAKE / EXHAUST _0388406 INTAKE MANIFOLD A

B48 INTAKE / EXHAUST  INTAKE MANIFOLD  INSTALLATION  


PROCEDURE

Hide 17111 1.INSTALL INTAKE MANIFOLD

HINT:

Make sure that the connections are locked correctly. The locks must engage audibly.


a.
A442209

Replace gasket (1).


b.
A441500

Replace the throttle body gasket (1).


c.
A441501

Replace the throttle body gasket (1).


d.

Position throttle body with motor assembly.


e.

Tighten the screws.

Torque:
7.0 N*m (71 kgf*cm, 62 in.*lbf)


f.

Position No. 3 fuel tank breather tube.


g.

Tighten down T20 bolts.

Torque:
3.0 N*m (31 kgf*cm, 27 in.*lbf)


h.

Mount the clip.


i.

Tighten down T25 bolts.

Torque:
4.0 N*m (41 kgf*cm, 35 in.*lbf)


j.

Mount the clip (1).


k.

Install the vacuum sensor assembly.


l.
A441767

Replace No. 1 intake manifold to head gaskets (1).

HINT:

Additional coolant can escape. Make sure that no coolant enters the intake port of the cylinder head.



m.
A441766

Position the intake manifold at the cylinder head.


n.

If required, connect the connectors.


o.

Tighten bolts in the order (1) to (5).

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)

NOTICE:

Tighten the bolts in increments with full turns.



p.

Tighten the E10 bolts (1).

Torque:
8.0 N*m (82 kgf*cm, 71 in.*lbf)


q.

Route the No. 3 engine wire correctly.


r.

Connect connectors and lock.


s.

Position the No. 4 engine wire and install holder.


t.

Mount and engage the fuel suction tube sub-assembly.


u.

Connect connectors and lock.


v.

Clip in the holder together with the water by-pass hose at the intake manifold.


w.

Mount the engine wire and engage the holder.


x.

Replace the hose clamp.


y.

Connect the water by-pass hose and mount the hose clamp.


z.

Connect and lock the water by-pass hose.

HINT:

The coolant line must audibly engage.



Hide 23285A 4.INSTALL NO. 1 CHECK VALVE

Hide 11271A 5.INSTALL REAR CYLINDER BLOCK COVER

Hide 55788A 6.INSTALL COWL TOP VENTILATOR LOUVER PROTECTOR

Hide 53681 7.INSTALL UPPER CENTER FRONT SUSPENSION BRACE

Hide 9.ADD ENGINE COOLANT (for Low Temperature)

Hide 51219 10.INSTALL FRONT LOWER SUSPENSION MEMBER PROTECTOR