Home › Engine / Hybrid System › B48 (ENGINE CONTROL) › ENGINE WIRE HARNESS (for No. 4)
RM3650E _51 Engine / Hybrid System _080056 B48 ENGINE CONTROL _0388317 ENGINE WIRE HARNESS(for No. 4) A

B48 ENGINE CONTROL  ENGINE WIRE HARNESS(for No. 4)  INSTALLATION  


PROCEDURE

Hide 82124 1.INSTALL NO. 4 ENGINE WIRE

NOTICE:
·

Improper routing of cables and wiring harnesses.

Trapped, crushed or damaged cables may cause short circuits and malfunctions.

-

Route all cables without abrasions, do not trap and crush.




a.
A442172

Insert and install the No. 4 engine wire (2).


b.

Clip in the No. 4 engine wire (2) in the marked area.


c.

Tighten down nut (1).

Torque:
5.0 N*m (51 kgf*cm, 44 in.*lbf)


d.
A442219

Secure the clamp (1).

HINT:

The clamp (1) must engage audibly.



e.

Connect and lock the holder (2).


f.

Connect and lock the holder (3).


g.

Connect and lock the holder (4).

HINT:

All holders must engage audibly.



h.
A442156

Connect all connectors (arrows) to the injectors and lock.

HINT:

The connectors must engage audibly.



i.

Connect the connector to the injectors.


j.
A441737

Engage lock (1) in direction of arrow audibly.


k.
A442157

Connect and lock all connectors (arrows).

HINT:

The connectors must engage audibly.



l.
A442154

Connect and lock all connectors (1) in the direction of the arrow.

HINT:

The connectors must engage audibly.



m.
A442111

Install the engine room ECU cover (2).

HINT:

The snap-lock couplings (1) must engage audibly.



Hide 11271A 2.INSTALL REAR CYLINDER BLOCK COVER

Hide 55788A 3.INSTALL COWL TOP VENTILATOR LOUVER PROTECTOR

Hide 12601B 4.INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY

Hide 53681 5.INSTALL UPPER FRONT SUSPENSION CENTER BRACE

Hide 6.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL