Home › Engine / Hybrid System › B48 (ENGINE CONTROL) › ENGINE OIL TEMPERATURE SENSOR
RM3650E _51 Engine / Hybrid System _080056 B48 ENGINE CONTROL _0388328 ENGINE OIL TEMPERATURE SENSOR A

B48 ENGINE CONTROL  ENGINE OIL TEMPERATURE SENSOR  INSTALLATION  


PROCEDURE

Hide 89429 1.INSTALL OIL TEMPERATURE SENSOR

a.
A441836

Replace O-ring (1).


b.

Install the oil temperature sensor on the cylinder block sub-assembly.


c.

Tighten down T30 bolt.

Torque:
8.0 N*m (82 kgf*cm, 71 in.*lbf)


d.

Connect the connector.

HINT:

The connector must engage audibly.