Home › Engine / Hybrid System › B58 (ENGINE CONTROL) › SERVO MOTOR
RM3650E _51 Engine / Hybrid System _080064 B58 ENGINE CONTROL _0388343 SERVO MOTOR A

B58 ENGINE CONTROL  SERVO MOTOR  REMOVAL  


CAUTION / NOTICE / HINT

CAUTION:
·

Hot surfaces.

Risk of burning!

-

Perform all work only on components that have cooled down.




PROCEDURE

Hide 12180E 1.REMOVE OIL FILLER CAP ASSEMBLY

Hide 12101A 2.REMOVE OIL PAN DRAIN PLUG

Hide 12101A 3.INSTALL OIL PAN DRAIN PLUG

Hide 22030 4.REMOVE THROTTLE BODY WITH MOTOR ASSEMBLY

Hide 15330G 5.REMOVE SERVO MOTOR

CAUTION:
·

Hot surfaces.

Risk of burning!

-

Perform all work only on components that have cooled down.




NOTICE:
·

Contaminant or foreign body.

Contamination can result in malfunctions, operating failure or leaks.

-

Adhere to the utmost cleanliness.

-

Protect components from contamination e.g. by covering.

-

Close off line connections with O-rings plugs.




HINT:

Collect and dispose of emerging fluids. Observe country-specific waste disposal regulations.


a.
A441280

Unlock ventilation line (1) and pull off from intake manifold.


b.

Unlock connector (2) and pull off.


c.
A441281

Push wiring harness to the side and unclip where required.


d.

Have a cleaning cloth ready.

HINT:

Engine oil may emerge when pulling off the servo motor for the eccentric shaft.



e.

Loosen T30 bolts (1).


f.
A441282

Using a 4 mm hexagon wrench, turn servo motor for the eccentric shaft (1) to the left on the bolt in the marked area and pull off the cylinder head at the same time.

NOTICE:

Do not turn the eccentric shaft beyond the end stop.


HINT:

This releases the tension of the eccentric shaft.



g.

Removing the servo motor for the eccentric shaft (1).