Hot surfaces.
Risk of burning!
Perform all work only on components that have cooled down.
17882
1.REMOVE NO. 2 AIR CLEANER HOSE
22030
2.REMOVE THROTTLE BODY WITH MOTOR ASSEMBLY
Electrostatic discharge.
Damage to or destruction of electrical components.
Only touch the housings of electrical components. Do not touch pins or multi-pin connectors directly.
For additional information see:
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
Loosen E10 bolt (1).
Loosen bolts (2).
Thread the throttle body with motor assembly (2) a little bit out to the front.
Unlock plug connection (1) and disconnect.
Remove throttle body with motor assembly (2).