11102A
1.INSTALL CAMSHAFT POSITION SENSOR (for Exhaust Side)
Replace O-ring (1).
Guide the camshaft position sensor of the exhaust camshaft in and install.
Tighten down T20 bolt.
Connect connectors and lock.
The connector must engage audibly.
11102A
2.INSTALL CAMSHAFT POSITION SENSOR (for Intake Side)
Replace O-ring (1).
Thread in and install the camshaft position sensor of the intake camshaft.
Tighten down T20 bolt.
Connect and lock the connector.
The connector must engage audibly.
12601B
3.INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY