Home › Engine / Hybrid System › B58 (ENGINE CONTROL) › CRANKSHAFT POSITION SENSOR
RM3650E _51 Engine / Hybrid System _080064 B58 ENGINE CONTROL _0388351 CRANKSHAFT POSITION SENSOR A

B58 ENGINE CONTROL  CRANKSHAFT POSITION SENSOR  INSTALLATION  


PROCEDURE

Hide 1.INSTALL CRANKSHAFT POSITION SENSOR

a.

Guide in and install crankshaft position sensor and install.


b.

Tighten down 4 mm hexagon bolt.

Torque:
4.6 N*m (47 kgf*cm, 41 in.*lbf)


c.

Connect connectors and lock.

HINT:

The connector must engage audibly.



Hide 32923K 2.INSTALL NO. 2 AUTOMATIC TRANSMISSION OIL COOLER TUBE CLAMP

a.

Position the No. 2 automatic transmission oil cooler tube clamp for the transmission oil lines at the engine block and clip in the transmission oil lines.


b.

Join and tighten the E8 bolt.

Torque:
8.0 N*m (82 kgf*cm, 71 in.*lbf)


c.

Clip in the cable clip.


Hide 32923L 3.INSTALL NO. 3 AUTOMATIC TRANSMISSION OIL COOLER TUBE CLAMP

a.

Position the upper section of the No. 3 automatic transmission oil cooler tube clamp for the transmission oil lines and tighten the T25 screw.

Torque:
5.0 N*m (51 kgf*cm, 44 in.*lbf)


Hide 51219 4.INSTALL FRONT SUSPENSION MEMBER LOWER PROTECTOR