Home › Engine / Hybrid System › B58 (ENGINE CONTROL) › KNOCK SENSOR
RM3650E _51 Engine / Hybrid System _080064 B58 ENGINE CONTROL _0388358 KNOCK SENSOR A

B58 ENGINE CONTROL  KNOCK SENSOR  INSTALLATION  


PROCEDURE

Hide 89615 1.INSTALL KNOCK SENSOR (for Bank 2)

NOTICE:

When installing the knock sensor, the tightening torque must be observed.

Non-compliance with the tightening torque can lead to malfunction.


a.

Clean the contact surface of the knock sensor at the crankcase.


b.

Install knock sensor.


c.

Tighten down E10 bolt.

Torque:
21.5 N*m (219 kgf*cm, 16 ft.*lbf)


d.

Connect the connector, it should lock audibly.


Hide 89615 2.INSTALL KNOCK SENSOR (for Bank 1)

NOTICE:

When installing the knock sensor, the tightening torque must be observed.

Non-compliance with the tightening torque can lead to malfunction.


a.

Clean the contact surface of the knock sensor at the crankcase.


b.

Install knock sensor.


c.

Tighten down E10 bolt.

Torque:
21.5 N*m (219 kgf*cm, 16 ft.*lbf)


d.

Connect the connector, it should lock audibly.


e.
A442197

Insert and install the intake manifold stay (2).


f.

Tighten the E8 bolts (1).

Torque:
8.0 N*m (82 kgf*cm, 71 in.*lbf)


g.

Secure the wiring harness and the coolant lines on the intake manifold stay (2).