Perform wheel alignment after installation.
12101
1.REMOVE OIL PAN SUB-ASSEMBLY
15100
2.REMOVE OIL PUMP ASSEMBLY
Collect and dispose of emerging fluids. Observe country-specific waste disposal regulations.
Contaminant or foreign body.
Contamination can result in malfunctions, operating failure or leaks.
Adhere to the utmost cleanliness.
Protect components from contamination e.g. by covering.
Close off line connections with seal plugs.
Release T45 bolt (1) with the special tool 2 463 965.
The thread is a left-hand thread.
Thread out the T45 bolt (1) and remove it.
Detach the oil pump drive shaft gear (1) from the oil pump assembly (3).
Feed the oil pump drive shaft gear (1) out of the oil pump drive chain sub-assembly (2) and remove it.
Loosen E10 bolts (1).
Pull the oil pump assembly (1) down slightly, work it out from the oil pump drive chain sub-assembly and remove.