Home › Engine / Hybrid System › B48 (LUBRICATION) › OIL PAN
RM3650E _51 Engine / Hybrid System _080065 B48 LUBRICATION _0394471 OIL PAN A

B48 LUBRICATION  OIL PAN  REMOVAL  


CAUTION / NOTICE / HINT

HINT:

Perform wheel alignment after installation.


PROCEDURE

Hide 51201 1.SEPARATE FRONT SUSPENSION CROSSMEMBER SUB-ASSEMBLY

Hide 12101A 2.REMOVE OIL PAN DRAIN PLUG

Hide 12101A 3.INSTALL OIL PAN DRAIN PLUG

Hide 28100 4.REMOVE STARTER ASSEMBLY

Hide 12101 5.REMOVE OIL PAN SUB-ASSEMBLY

a.
A441198

Unlock plug connection (1) and disconnect.


b.

Release the cable from the clips (2) of the oil pan sub-assembly.


c.
A441199

Unscrew the transmission E10 bolts (1).


d.
A441247

Loosen E10 bolts (1), (2) and (3).


e.
A441245

Loosen E10 bolts (1) to (7).


f.
A441246

Loosen E10 bolts (1) to (7).


g.
A441200

Loosen E10 bolts (1) and (2).


h.
A444616

Loosen the oil pan sub-assembly in the marked areas.

HINT:

Increased force may be necessary during disassembly because the component is bonded with seal packing.



i.
A441225

Remove oil pan sub-assembly (1) from the bottom rear.


Hide 12101 6.REPLACE OIL PAN SUB-ASSEMBLY

CAUTION:
·

Hot surfaces.

Risk of burning!

-

Perform all work only on components that have cooled down.




NOTICE:
·

Electrostatic discharge.

Damage to or destruction of electrical components.

-

Only touch the housings of electrical components. Do not touch pins or multi-pin connectors directly.

-

For additional information see:

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION




a.
A444623

Loosen nuts (1).


b.

Remove the engine oil level sensor (2).


c.
A442076

Guide the seal plug (1) out of the oil pan sub-assembly (2) in the direction of the arrow and remove.


d.

Replace oil pan sub-assembly.


e.
A442077

Guide the seal plug (1) into the oil pan sub-assembly (2) in the direction of the arrow and install.