Home › Engine / Hybrid System › B58 (LUBRICATION) › OIL PUMP
RM3650E _51 Engine / Hybrid System _080066 B58 LUBRICATION _0388391 OIL PUMP A

B58 LUBRICATION  OIL PUMP  REMOVAL  


CAUTION / NOTICE / HINT

HINT:

Perform wheel alignment after installation.


PROCEDURE

Hide 12101 1.REMOVE OIL PAN SUB-ASSEMBLY

Hide 15100 2.REMOVE OIL PUMP ASSEMBLY

CAUTION:

Collect and dispose of emerging fluids. Observe country-specific waste disposal regulations.


NOTICE:
·

Contaminant or foreign body.

Contamination can result in malfunctions, operating failure or leaks.

-

Adhere to the utmost cleanliness.

-

Protect components from contamination e.g. by covering.

-

Close off line connections with seal plugs.




a.
A441446

Release T45 bolt (1) with the special tool 2 463 965.

SST
09900-WA180  

HINT:

The thread is a left-hand thread.



b.
A441447

Thread out the T45 bolt (1) and remove it.


c.
A441448

Detach the oil pump drive shaft gear (1) from the oil pump assembly (3).


d.

Feed the oil pump drive shaft gear (1) out of the oil pump drive chain sub-assembly (2) and remove it.


e.
A441227

Loosen E10 bolts (1) of the oil pump assembly (2).


f.
A441228

Pull the oil pump assembly (1) down slightly, work it out from the oil pump drive chain sub-assembly (2) and remove.


Hide 15104 3.REPLACE OIL STRAINER SUB-ASSEMBLY

a.
A441334

Loosen bolts (1).


b.

Feed out and remove oil strainer sub-assembly (2) from the oil pump assembly.


c.
A441388

Check the O-ring for damage and replace the oil strainer sub-assembly if needed.


d.
A441334

Feed in and position oil strainer sub-assembly (2).


e.

Tighten the bolts (1).

Torque:
8.0 N*m (82 kgf*cm, 71 in.*lbf)