Home › Engine / Hybrid System › B48 (INTAKE / EXHAUST) › CENTER EXHAUST PIPE
RM3650E _51 Engine / Hybrid System _080067 B48 INTAKE / EXHAUST _0388413 CENTER EXHAUST PIPE A

B48 INTAKE / EXHAUST  CENTER EXHAUST PIPE  REMOVAL  


CAUTION / NOTICE / HINT

CAUTION:
·

Hot exhaust system.

Risk of burning!

-

Any work must exclusively be carried out with an exhaust system that has cooled down.



·

Hot surfaces.

Risk of burning!

-

Perform all work only on components that have cooled down.



·

Component with heavy weight.

Danger of injury!

-

Note component's center of gravity.

-

Support component using a jack.

-

Secure component against falling off the jack.



·

Swarf resulting from sawing or grinding components.

Danger of injury!

-

Conduct all work in appropriate personal protective equipment only.

-

Wear safety goggles and protective gloves.




PROCEDURE

Hide 57628E 1.REMOVE REAR FLOOR SIDE MEMBER COVER LH

Hide 57627G 2.REMOVE REAR FLOOR SIDE MEMBER COVER RH

HINT:

Use the same procedure as for the LH side.


Hide 58252 3.REMOVE REAR FLOOR PANEL BRACE

Hide 17410 4.REMOVE CENTER EXHAUST PIPE ASSEMBLY

a.
A442366

Separation point for the renewal of the center exhaust pipe assembly.

CAUTION:
·

Hot surfaces.

Risk of burning!

-

Perform all work only on components that have cooled down.



·

Heavy component.

Heavy components can lead to injury or damage.

-

Remove and install heavy components with the aid of another person/other persons.




NOTICE:

Check the exhaust system for tightness after installation.


HINT:
·

If the separation point is not marked by a punch mark in the pipe, determine the separation point by means of the pipe length on the new component.

·

Transfer the separation point to the faulty component and mark.

·

Cut through the faulty component at the marked point with a suitable tool.

·

Deburr the separation point and remove any swarf. There is a risk of remaining metal chips at the joint between the two pipes and/or swarf in the rear silencer.




b.
C406340

Detach the center exhaust pipe assembly with the special tool 0 496 469 (00 2 220) at the separation point.

SST
09200-WA600  


c.
A442368

for Ribbon Clamp:

i.

Detach the clamp.



d.
A442369

for V-band clamp:

i.

Loosen V-band clamp (1).



e.
A442367

Unscrew the nut (1) on the holder (2).


f.

Remove the center exhaust pipe assembly with an auxiliary person.