Home › Engine / Hybrid System › B48 (INTAKE / EXHAUST) › CENTER EXHAUST PIPE
RM3650E _51 Engine / Hybrid System _080067 B48 INTAKE / EXHAUST _0388413 CENTER EXHAUST PIPE A

B48 INTAKE / EXHAUST  CENTER EXHAUST PIPE  INSTALLATION  


PROCEDURE

Hide 17410 1.INSTALL CENTER EXHAUST PIPE ASSEMBLY

a.

Replace the center exhaust pipe assembly.


b.

Install the center exhaust pipe assembly with an auxiliary person.


c.

Check the rubber mounts for damage and replace, if necessary.


d.

Replace nut.


e.

Tighten the nut on the holder.

Torque:
19 N*m (194 kgf*cm, 14 ft.*lbf)


f.

for Ribbon Clamp:

i.
A441588

Open the weld seam (1) with a hacksaw.


ii.

Remove the exhaust pipe clamp (2).


iii.

Replace the exhaust pipe clamp.


iv.

Tighten the exhaust pipe clamp.

Torque:
26 N*m (265 kgf*cm, 19 ft.*lbf)



g.
A442376

for V-band Clamp:

i.

Install V-band clamp.


ii.
A442377

Unscrew the nut (1) and remove the sealing ring (2).


iii.
A442378

Mount the sealing ring (1) on the center exhaust pipe assembly.

NOTICE:

Make sure that the sealing ring (1) is correctly positioned for the V-clip (2).



iv.
A442379

Bend all sheet metal tabs over with a suitable tool, except those in the marked areas.


v.
A442380

Mount the V-clip (1) on the sealing ring (2).

NOTICE:
·

Make sure that the V-clip (1) is positioned correctly on the sealing ring (2).

·
A442383

Make sure that the V-clip rests against the sheet metal tabs after mounting (marks).




vi.
A442381

Connect the exhaust pipe assembly (1) with the catalytic converter (2) and position correctly.

NOTICE:
A442382

Make sure that V-clip (1) is fitted correctly.



vii.

Tighten down screw (2).

Torque:
25 N*m (255 kgf*cm, 18 ft.*lbf)



h.
A442370

Connect the center exhaust pipe assembly to the tail exhaust pipe assembly with the clamp (1).


i.

Center the clamp (1) and tighten the nuts (2).

Torque:
45 N*m (459 kgf*cm, 33 ft.*lbf)


Hide 58252 2.INSTALL REAR FLOOR PANEL BRACE

Hide 57628E 3.INSTALL REAR FLOOR SIDE MEMBER COVER LH

Hide 57627G 4.INSTALL REAR FLOOR SIDE MEMBER COVER RH

HINT:

Use the same procedure as for the LH side.