Home › Engine / Hybrid System › B48 (INTAKE / EXHAUST) › INLET TURBO OIL PIPE
RM3650E _51 Engine / Hybrid System _080067 B48 INTAKE / EXHAUST _0388415 INLET TURBO OIL PIPE A

B48 INTAKE / EXHAUST  INLET TURBO OIL PIPE  REMOVAL  


CAUTION / NOTICE / HINT

CAUTION:
·

Hot fluids.

Risk of scalding!

-

Conduct all work in the vehicle wearing appropriate personal protective equipment only.


·

Hot surfaces.

Risk of burning!

-

Perform all work only on components that have cooled down.




HINT:

Collect and dispose of emerging fluids. Observe country-specific waste disposal regulations.


PROCEDURE

Hide 11401T 1.REMOVE CYLINDER BLOCK COVER

Hide 15407 2.INSTALL INLET TURBO OIL PIPE SUB-ASSEMBLY

CAUTION:
·

Hot surfaces.

Risk of burning!

-

Conduct all work in the vehicle wearing appropriate personal protective equipment only.




a.
A441847

Release the T30 bolt (1) and pull off the turbo oil inlet pipe sub-assembly (2) for the turbocharger sub-assembly.


b.
A441825

Release the T30 bolt (1) and remove the inlet turbo oil pipe sub-assembly (2) for the turbocharger sub-assembly.

NOTICE:
·

Collect and dispose of emerging fluids. Observe country-specific waste disposal regulations.

·

Have a shop towol ready and catch any engine oil that may emerge.

·

Make sure no engine oil runs onto belt drive.