Home › General › MAINTENANCE › B48 DRIVE BELT
RM3650E _V1 General _079881 MAINTENANCE _0388856 B48 DRIVE BELT A

MAINTENANCE  B48 DRIVE BELT  REMOVAL  


PROCEDURE

Hide 12601B 1.REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY

Hide 17882 2.REMOVE NO. 2 AIR CLEANER HOSE

Hide 11401T 3.REMOVE CYLINDER BLOCK COVER

a.
A441753

Loosen clamps (1).


b.

Release all expanding rivets in marked areas.


c.

Guide out the cylinder block cover (2).


Hide 16109 4.REMOVE WATER PUMP SUB-ASSEMBLY

a.
A442309

Unlock and loosen connector (1).


b.

Unscrew the nut (2) on the holder.


c.

Guide the water pump sub-assembly (3) out of the holder and set it aside.


Hide 5.REMOVE FAN AND GENERATOR V BELT

CAUTION:
·

Component with preload.

Danger of injury!

-

Reduce preload as far as possible before disassembly. Relieve component.




HINT:

If the fan and generator V belt is reused: Mark the direction of travel and reinstall the fan and generator V belt in same direction of travel.


a.
A445282C01
2.031,1.823 2.5,1.5 true 2.49,1.375 2.802,1.531 0.313,0.156 10 true *a
*a 4 mm Hexagon Wrench


Using 16 mm socket, raise the preloading on the belt tensioner (1) in the direction of arrow.


b.

Secure the belt tensioner (1) with the 4 mm hexagon wrench.


c.
A441806

Guide out the fan and generator V belt (1) and remove it.