Home › Engine / Hybrid System › B48 (INTAKE / EXHAUST) › TAIL EXHAUST PIPE ASSEMBLY
RM3650E _51 Engine / Hybrid System _080067 B48 INTAKE / EXHAUST _0388420 TAIL EXHAUST PIPE ASSEMBLY A

B48 INTAKE / EXHAUST  TAIL EXHAUST PIPE ASSEMBLY  INSTALLATION  


PROCEDURE

Hide 17430 1.INSTALL TAIL EXHAUST PIPE ASSEMBLY

NOTICE:

Check the exhaust system for tightness after installation.


a.

Guide the clamp onto the tail exhaust pipe assembly.


b.

Insert tail exhaust pipe assembly and install.


c.

Replace nut.


d.

Tighten the nut on the holder.

Torque:
19 N*m (194 kgf*cm, 14 ft.*lbf)


e.

Replace nuts.


f.

Tighten the nuts on the holder.

Torque:
19 N*m (194 kgf*cm, 14 ft.*lbf)


g.

Replace nuts.


h.

Tighten the nuts on the holder.

Torque:
19 N*m (194 kgf*cm, 14 ft.*lbf)


i.
A442364

Connect the tail exhaust pipe assembly with the center exhaust pipe assembly with the clamp (1).

NOTICE:

The separation point must be centered.



j.

Center the tail No. 1 exhaust pipe clamp (1) and tighten the nuts (2).

Torque:
45 N*m (459 kgf*cm, 33 ft.*lbf)


k.

Connect connectors and lock.


Hide 58724G 2.INSTALL REAR UNDERBODY PROTECTOR LH

Hide 58723F 3.INSTALL REAR UNDERBODY PROTECTOR RH

HINT:

Use the same procedure as for the LH side.


Hide 58252 4.INSTALL REAR FLOOR PANEL BRACE

Hide 57628E 5.INSTALL REAR FLOOR SIDE MEMBER COVER LH

Hide 57627G 6.INSTALL REAR FLOOR SIDE MEMBER COVER RH

HINT:

Use the same procedure as for the LH side.