Home › Vehicle Interior › SEAT › LUMBAR SUPPORT ADJUSTER ASSEMBLY
RM3650E _58 Vehicle Interior _080097 SEAT _0388588 LUMBAR SUPPORT ADJUSTER ASSEMBLY A

SEAT  LUMBAR SUPPORT ADJUSTER ASSEMBLY  INSTALLATION  


CAUTION / NOTICE / HINT

CAUTION:

Wear protective gloves. Sharp areas on the parts may injure your hands.


HINT:
·

Use the same procedure for RHD and LHD vehicles.

·

The procedure listed below is for LHD vehicles.

·

Use the same procedure for the driver side and front passenger side.

·

The procedure listed below is for the driver side.



PROCEDURE

Hide 72760D 1.INSTALL LUMBAR SUPPORT ADJUSTER ASSEMBLY

a.
B539963

Install the lumbar support adjuster assembly (1) in the marked areas (3) to the spring wire (2).


b.
B539966

Install the pump (3) correctly.


c.

Install the tie band (1).


d.

Connect the connector (2).


e.

w/ Back Side Support Adjuster:

i.
B539958

Install the valve units (3) correctly to the spring wire.


ii.

Attach the pneumatic tubes to the holders in the marked area (4).


iii.

Connect the pneumatic tubes connector (2).


iv.

Connect the connectors (1).



f.

w/o Back Side Support Adjuster:

i.
B539965

Install the valve unit (2) correctly to the spring wire.


ii.

Attach the pneumatic tubes to the holder in the marked area (3).


iii.

Connect the connector (1).



Hide 2.INSTALL SEPARATE TYPE FRONT SEATBACK COVER WITH PAD (for Manual Seat)

Hide 3.INSTALL SEPARATE TYPE FRONT SEATBACK COVER WITH PAD (for Power Seat)