Home › Engine / Hybrid System › B48 (FUEL) › FUEL PUMP (for High Pressure)
RM3650E _51 Engine / Hybrid System _080098 B48 FUEL _0388603 FUEL PUMP(for High Pressure) A

B48 FUEL  FUEL PUMP(for High Pressure)  INSTALLATION  


PROCEDURE

Hide 23470 1.ADJUST FUEL PUMP LIFTER ASSEMBLY

a.

Rotate the cam of the high pressure pump drive to the BDC position

NOTICE:
·

Damage to the engine.

·

The engine may be damaged if it is manually rotated in the wrong direction.

-

Always rotate the engine in the correct direction of rotation by hand: a) Clockwise, facing the vibration damper or b) Counter-clockwise, facing the chain drive. (b) only applies when the rear timing chain is installed.





b.
A441494

Using a vernier caliper and straightedge flat onto the high pressure pump flange.


c.

Turn the engine on the central bolt in the direction of engine rotation until the camshaft has reached the BDC position.

i.

The vernier caliper is in the deepest position.



d.
A441560

Loosen cover (1).


e.
A441561

Rotate the engine with the special tool 0 493 380 (11 6 480) in the direction of the arrow until the cam of the high pressure pump drive is at the BDC position .


f.
A441738

Check the threads (1) on the high pressure pump flange for sealing compound residue: Remove sealing compound residue as needed.


g.

Clean the thread (1) with a thread cutter M6.


h.

Make sure that no contamination enters the engine.


i.

Cover opening at the high pressure pump flange with suitable materials.


j.
A441721

Renew gasket (1).


Hide 23100X 2.INSTALL FUEL PUMP ASSEMBLY

a.
A441539

Feed in and install high pressure pump (2).


b.

Renew the bolts (arrows).

HINT:

Compliance with the specification is imperative to make sure that the piston will not break due to twisting.



c.

Position screws (arrows) of the high pressure pump (2) and tighten in alternating order in 90° increments.

Torque:
12 N*m (122 kgf*cm, 9 ft.*lbf)


Hide 23802B 3.INSTALL NO.2 FUEL PIPE SUB-ASSEMBLY

Hide 23801P 4.INSTALL NO.1 FUEL PIPE SUB-ASSEMBLY