23801P
1.INSTALL NO. 1 FUEL PIPE SUB-ASSEMBLY
Insert the No. 1 fuel pipe sub-assembly (4) into the holder (3) and install.
Tighten union nuts (arrows) with the 17 mm union nut wrench.
Insert and install the wiring harness section of the engine wiring harness (4).
The locks (3) must engage audibly.
Connect connectors (1) and (2) and lock.
The connectors (1) and (2) must audibly engage.
12602D
2.INSTALL NO.2 ENGINE COVER SUB-ASSEMBLY
Guide in and install No.2 engine cover sub-assembly (1).
3.INSTALL IGNITION COIL ASSEMBLY