Home › Engine / Hybrid System › B58 (ENGINE CONTROL) › IGNITION COIL AND SPARK PLUG
RM3650E _51 Engine / Hybrid System _080064 B58 ENGINE CONTROL _0388352 IGNITION COIL AND SPARK PLUG A

B58 ENGINE CONTROL  IGNITION COIL AND SPARK PLUG  INSTALLATION  


PROCEDURE

Hide 1.INSTALL SPARK PLUG

Hide 2.INSTALL IGNITION COIL

a.

Install ignition coil.


b.

Tighten down E8 bolt.

Torque:
8.0 N*m (82 kgf*cm, 71 in.*lbf)


c.

Connect connectors and lock.

HINT:

The connector must engage audibly.



d.
A442205

Connect the connectors (1) of the No. 2 oxygen sensor and the No. 2 air fuel ratio sensor on the cable shaft (2).


Hide 12611 3.INSTALL NO. 1 ENGINE COVER

a.
A442114

Turn the No. 1 engine cover (2) at the pivot point (1) to the installation position and guide it in where marked (arrows).


Hide 12601B 4.INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY