Home › Engine / Hybrid System › B58 (FUEL) › FUEL TUBE (for Rear)
RM3650E _51 Engine / Hybrid System _080099 B58 FUEL _0388629 FUEL TUBE(for Rear) A

B58 FUEL  FUEL TUBE(for Rear)  REMOVAL  


CAUTION / NOTICE / HINT

CAUTION:
·

Working on 12 V vehicle electrical system.

Risk of short circuits! Risk of fire!

-

Detach battery earth lead from battery.

-

For an auxiliary battery: Disconnect battery earth lead of auxiliary battery.




NOTICE:
·

Damage to battery terminal, the safety battery terminal or the intelligent battery sensor (IBS).

Damaged battery terminals can lead to malfunctions or vehicle electrical system faults.

-

Pull off battery terminal from battery pole by carefully moving to and fro. Do not pry off using a tool.




PROCEDURE

Hide 1. DISCHARGE FUEL SYSTEM PRESSURE

Hide 12602D 2.REMOVE NO. 2 ENGINE COVER SUB-ASSEMBLY

Hide 23802B 3.REMOVE NO. 2 FUEL PIPE SUB-ASSEMBLY

CAUTION:
·

Working on fuel system.

Risk of fire! Danger of explosion!

-

When working on the fuel system, make sure that the workbay is sufficiently ventilated, e.g. using extraction unit.

-

Tightly seal off open lines and connections; collect any escaping fuel directly at the point of exit.

-

No fire, sparks, open flames or smoking.


·

On releasing high pressure line, fuel may emerge at high speed.

Danger of injury!

-

Wear suitable personal protective equipment.

-

Allow the cooling system to cool down to a temperature below 40°C before starting installation work.

-

Note warnings on cylinder head cover.




NOTICE:
·

Electrostatic discharge.

Damage to or destruction of electrical components.

-

Leave electrical components in original packaging until just before they are installed. Use the original packaging only for any return shipments. Always package removed components straight away.

-

Read and comply with user information on using the associated special tool 12 7 060.

-

Only touch the housings of electrical components. Do not touch pins or multi-pin connectors directly.

-

Anti static work clothing and antistatic shoes (with ESD symbol).

-

For additional information see: 61 35 Information on electrostatic discharge (ESD) protection.




HINT:

Collect and dispose of emerging fluids. Observe country-specific waste disposal regulations.


a.
A442244

Unlock the snap fastener (1) in the direction of the arrow.


b.

Loosen fuel line (2) and place to one side.


c.

Catch and dispose of escaping fuel.


d.

Seal the fuel feed lines with special tools 0 496 567 (13 5 161) and 0 496 568 (13 5 162) from the set of special tools 0 496 565 (13 5 160).

SST
09200-WA130  


e.

Loosen screw (3).


f.
A442246

Unlock plug connection (1) and disconnect.


g.

Release the union nut (2) with the 17 mm union nut wrench on the high pressure pump.

SST
09200-WA630  


h.

Catch and dispose of escaping fuel.


i.

Guide the No. 2 fuel pipe sub-assembly (4) out of the holder (3).


j.

Guide the No. 2 fuel pipe sub-assembly (4) out and remove.