Home › Engine / Hybrid System › B58 (EMISSION CONTROL) › DIFFERENTIAL PRESSURE SENSOR
RM3650E _51 Engine / Hybrid System _080101 B58 EMISSION CONTROL _0388647 DIFFERENTIAL PRESSURE SENSOR A

B58 EMISSION CONTROL  DIFFERENTIAL PRESSURE SENSOR  INSTALLATION  


PROCEDURE

Hide 89481B 1.INSTALL DIFFERENTIAL PRESSURE SENSOR

HINT:

Check the vacuum transmitting hose assembly on the pressure sensor and/or the differential pressure sensor. Replace hardened vacuum transmitting hose assembly. Check connection on pressure pipe and pressure sensor for leaks.


a.
A441468

Thread in differential pressure sensor (3) on the holder (4) and install.

HINT:

The differential pressure sensor (3) must engage audibly.



b.

Check the vacuum transmitting hose assembly (2) for damage and replace where required.

HINT:

The vacuum transmitting hose assembly (2) must not be hardened or damaged.



c.

Push the vacuum transmitting hose assembly (2) in the direction of arrow till the limit position on the differential pressure sensor (3).


d.

Connect and lock the connector (1).

HINT:

The connector (1) must engage audibly.



e.
A441466

Guide in and install sensor cover (2).

HINT:

The cover (2) must engage audibly into the locks (arrows).



f.

Tighten down E6 screw (1).

Torque:
3.0 N*m (31 kgf*cm, 27 in.*lbf)


Hide 12601B 2.INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY