Home › Engine / Hybrid System › B48 (STARTING) › STARTER
RM3650E _51 Engine / Hybrid System _080068 B48 STARTING _0388695 STARTER A

B48 STARTING  STARTER  INSTALLATION  


PROCEDURE

Hide 28192 1.INSTALL STARTER COVER

a.

Install the starter cover to the starter assembly.


Hide 28100 2.INSTALL STARTER ASSEMBLY

a.
A442144

Insert and install the starter assembly (2).


b.

Tighten the E10 bolts (1).

Torque:
19 N*m (194 kgf*cm, 14 ft.*lbf)


Hide 12140 3.INSTALL OIL PAN COVER

CAUTION:
·

Improper routing of the positive battery cable.

·

Risk of short circuits!

-

Route the positive battery cable without abrasions and do not trap.




a.
A441950

Position the oil pan cover (2).


b.

Replace the clip (1).


c.

Install the clip (1).


d.

Install the clips in the marked areas.


e.
A441951

Clip the transmission wire (1) into the marked areas at the oil pan cover.


f.
A442143

Connect the transmission wire (4) for the terminal 50 to the starter assembly.


g.

Connect the connector (3).

HINT:

The connector must engage audibly.



h.

Position starter wiring assembly (2) on the starter assembly.


i.

Tighten nut (1).

Torque:
13.5 N*m (138 kgf*cm, 10 ft.*lbf)


Hide 51219 4.INSTALL FRONT SUSPENSION MEMBER LOWER PROTECTOR

Hide 5.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL