1.INSTALL STARTER WIRING ASSEMBLY
Improper routing of the positive battery cable.
Risk of short circuits!
Route the positive battery cable without abrasions and do not trap.
Insert and install the starter wiring assembly (1).
Secure the clamps (arrows).
Insert and install the No. 2 front floor heat Insulator (2).
Tighten nuts (1).
Position the starter wiring assembly (2) to the starter assembly.
Tighten nut (1).
Position the starter wiring assembly (3) to the positive battery terminal.
Secure clamps (2).
Tighten nut (1).
Insert and install the terminal cover (2) in the direction of the arrow.
The locks (1) must engage audibly.
51219
2.INSTALL FRONT SUSPENSION MEMBER LOWER PROTECTOR
12601B
3.INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY
4.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL