Home › Engine / Hybrid System › B48 (COOLING) › FAN SHROUD
RM3650E _51 Engine / Hybrid System _080127 B48 COOLING _0388717 FAN SHROUD A

B48 COOLING  FAN SHROUD  REMOVAL  


CAUTION / NOTICE / HINT

HINT:

When the engine is stopped after the end of the journey, it may be necessary to run the electric fan. In rare cases, operation of the electric fan can last up to 11 min. This protects the components. In this case, replacing the electric fan will not remedy the problem!


PROCEDURE

Hide 81150 1.REMOVE HEADLIGHT ASSEMBLY LH

Hide 81110 2.REMOVE HEADLIGHT ASSEMBLY RH

HINT:

Use the same procedure as for the LH side.


Hide 53111M 3.REMOVE FRONT BUMPER INNER SUPPORT

Hide 52521B 4.REMOVE FRONT BUMPER UPPER RETAINER

Hide 53295A 5.REMOVE RADIATOR UPPER AIR DEFLECTOR

Hide 53205 6.REMOVE UPPER RADIATOR SUPPORT SUB-ASSEMBLY

a.
A442524

Loosen the clips (1).


b.

Place wiring harness (2) to one side.


c.
A442531

Unclip the housing (1) in the marked areas.


d.

Detach the Bowden cables (2) at the separation point in the housing (1) where required.


e.
A442467

Loosen bolts (1).


f.

Loosen E14 bolts (2).


g.

Unscrew the bolts (3) and remove the upper radiator support sub-assembly.


Hide 16360A 7.REMOVE FAN WITH MOTOR ASSEMBLY

CAUTION:
·

Hot surfaces.

Risk of burning!

-

Perform all work only on components that have cooled down.




a.
A442290

Unlock and loosen clamp (1).


b.

Feed out automatic transmission oil cooler tube (2) and place to one side.


c.
A442291

Unlock and loosen connector (1).


d.

Loosen T30 bolt (2).


e.

Unlock the fan with motor assembly and remove it from the bracket (3) toward the top.