16020
1.INSTALL WATER PUMP ASSEMBLY
Check the sealing rings (1) of the coolant lines (2) for damage and renew, if necessary.
Position the water pump assembly with the No. 2 water pump bracket sub-assembly (1).
Note the installation position of the component. The component may be installed in various installation positions.
Make sure the mounting orientation is correct according to the marks (magnifying glass).
Tighten nut (2).
Connect and lock the No. 1 radiator hose (2) and No. 2 turbo water pipe sub-assembly (3).
Make sure that the connections are locked correctly. The locks must engage audibly.
Connect connector (5).
2.ADD ENGINE COOLANT (for High Temperature)
12601B
3.INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY
4.INSPECT FOR COOLANT LEAK (for High Temperature)
51219
5.INSTALL FRONT SUSPENSION MEMBER LOWER PROTECTOR